Pima County supervisors certify Nov. 3 general election results
TUCSON, Ariz. — The Pima County Board of Supervisors voted 4-0 on Thursday, Nov. 19, to approve and certify the canvass of the Nov. 3, 2026, general election. The board did so after the county's elections staff said all voting equipment passed pre-election testing and a post-election hand count audit came back within acceptable limits.
The canvass puts countywide turnout at 62.82%: 413,270 ballots cast by 657,885 registered voters. That includes 349,259 early ballots, 61,827 cast at the polls and 2,184 provisional ballots.
Supervisor Rex Scott was absent from the special meeting, which was held virtually and lasted about 12 minutes. Chair Jennifer Allen presided. Vice Chair Dr. Matt Heinz moved to approve the canvass, and Supervisor Andrés Cano seconded. The canvass was the only item on the agenda. It included results for school district and community college races, and a representative of the county school superintendent's office attended to ensure compliance with state law.
Under state law, the board must canvass the election. In a Nov. 17 memo to the board, Elections Director Constance L. Hargrove certified the results and recommended approval. The election official who presented the canvass told supervisors the results were "a complete and accurate representation of the election."
Ballot counts
According to the memo and the presentation, the Recorder's Office issued 503,170 early ballots. The Elections Department received and processed 331,955 of them, starting Oct. 13. The department also processed 17,304 early ID-verified ballots dropped off at vote centers, for a total of 349,259 early ballots processed and tabulated, along with election day ballots.
County voter registration records attached to the canvass list 657,885 active registered voters and 89,632 inactive voters as of the Oct. 5 registration cutoff. Of the active voters:
- 238,460 were Democrats.
- 180,560 were Republicans.
- 227,065 were registered in the "other" category.
- 6,219 were No Labels.
- 4,376 were Libertarians.
- 1,205 were Green Party.
Testing and audits
The memo said the voting equipment went through three logic and accuracy tests before any ballots were tabulated:
- An in-house test on Sept. 25.
- A test with Republican and Democratic party participation on Sept. 30.
- A Secretary of State test on Oct. 2, which both parties observed.
All three tests resulted in 100% accuracy, the memo said. The county's Information Technology Department ran hash validations on Sept. 25 and Oct. 2 to confirm the software in use was the version approved by the state and federal government.
The Elections Department conducted a hand count audit on Nov. 7. The memo said its results were within the range the Secretary of State specifies. The presenter told the board that election day ballots were also audited against the number of voters checked in, and that those figures came back within acceptable ranges as well. Party representatives were present as early ballots were processed, the memo said.
All vote centers opened on time at 6 a.m., and none experienced a disruption that kept a voter from casting a ballot, according to the memo.
Board comments
Cano thanked the county elections department and the Recorder's Office. "This is an election that took months of effort and it went off flawlessly," he said.
The presenting elections official credited the transportation, fleet and facilities departments and the Pima County Public Library with supporting the election. The official contrasted Pima County's experience with the problems colleagues across the state had reported, including flooding and polling locations that had to close.
Also discussed:
- Elections staff said ballot drop boxes drew a strong response from voters and that staff would share figures with the board at a later date.
This report was drafted by Claude Opus 5.5 from a live transcript produced by Deepgram Nova-2, then reviewed and edited by Nicholas De Leon with Claude Opus 5.5, and published at 2:38 PM MST on November 19, 2026. Read more about how this is made.
Comments
Join the conversation on Bluesky